Description

Having the correct tools is a must and a little preventative maintenance goes a long way. This kit helps the process of rear sensor replacement go as smooth as possible and  sets the new sensor in with the right gear. Kit includes:

(1) 2.5 mm hex bit – use to remove factory bolts. Fit it into the bolt head with some impact creating shock treatment and blasting through that surface rust.

(1) Scotch pad – for cleaning up sensor surface area.

(1) 4.0 x 0.7 mm bottom tap – for cleaning the motor housing threads.

(4) Oxidation resistant 4.0 x 0.7 mm Stainless bolts – for new sensor install.

(1) Anti-Seize – for new bolt threads.

(1) Dielectric grease – for GM connector pins

NOTE – THIS KIT COMES WITH THE REAR POSITION SENSOR. IF YOU PURCHASED A SENSOR THIS KIT WILL COME WITH IT